New breathable thermo-shirt „body-type” with extremely flexible heating wire, to be used as first underwear, directly on the body. Designed with heating power regulation – two steps 50% and 100%. Besides the heating capabilities, takes an important role of thermoactive underwear, keeping sweat out of the body.
The temperature is controlled by switching on and off the battery canister.
Switch it on, you hear one beep sound at full 100% power, switch it off and on you hear three beeps sound and it will give you 50% power.
Each next switching on and off changes the temperature mode
Very thin layer of fabric neither constrain the diver, nor create an air-trap. Contiguous in shape eliminates need of high temperatures to heat diver’s body, what effects in energy-saving design of the heating system, allowing long burn-times at low power. Burn-times for PERCH H10 (9.2 Ah) battery pack 240 minutes for 1st step, 130 minutes for 2nd step.
Thermo-shirt material reduces unpleasant smells after usage. Hand-washingusing agents suitable for thermoactive wear is possible.
Attention: In any circumstances do not use any other power sources than Yellow Diving battery packs. This can result in burns and damaging the heating system.
The shirt is made of a thin, breathable material that is stretchable in width as the wires run parallel on the front and back from top to bottom.
The shirt brings a heating power of 45W / 3.8AH / 11V
The heater can be operated at 50% or 100% power. Switching the battery tank once produces 3 beeps, the power is 50%. Switching again, a long beep will sound, and the heater will bring 100% power again.
This function allows the shirt to be worn directly on the skin. The shirt can be washed carefully by hand.
When operated with a10 AH LI battery tank 12 volts can be heated for about 2 hours!
The plug connection of the shirt is a bayonet plug, which is also compatible with Santi Valves!
( Thermovale Sitec or Apeks )
When using other battery tanks / plugs, it is imperative to observe the polarity, because of the dimming controller!
A really good alternative to many very thick and inflexible heating vests!
Heating vest
PERCH HU – breathable „body” type with a very flexible heating wire, to be
weared directly on naked body. Equipped with heating power regulator, two
steps, 50% and 100%. Besides heating function, takes the important role of
thermo-active underwear, to keep sweat out of the body.
Thin layer of fabric neither constrains diver body movements, nor creates an airtrap.
Contiguous in shape does not need high temperatures to heat diver body,
the whole system is energy-saving, what effects in longer burn-times.
Heating vest is manufactured from material limiting formation and retention of
unpleasing odours after usage. Hand washing is possible (30° C) with usage of
washing agents suitable for thermo-active wear. After washing do not wring,
hang loose to drain, dry well. Do not iron, do not dry in automatic dryers.
